Cutting tools across the stone process
Cutting tools for the full stone process — from block and slab cutting through to trimming and finishing. Selected against the material and the machine, stage by stage.
A stone works runs several cutting stages on the same material. Each stage loads the tool differently, so the tool is chosen per stage rather than per material alone.
Cutting tools must suit the machine spindle, feed and cooling. A correct tool on the wrong machine performs worse than a modest tool correctly matched.
In a producing works the cost of a stop is greater than the difference between two tool prices. We arrange supply against your consumption.
Values we can state from real applications, with the basis for each one.
Every specification above is confirmed against your material, machine and site conditions before an order is placed.
We specify against the job rather than the catalog. These are the facts that decide the answer for anything in Diamond Tools.
This product is specified as part of a set. These are the wire families and product groups it is normally combined with — final selection depends on the material, the machine and the site conditions.
Actual applications with the equipment, tooling and working conditions recorded.
How this equipment and tooling performs in real quarry and construction conditions.
Send the material, the machine and the working conditions. We will come back with a specification that suits the job — and say plainly where a limit exists.
