Hydraulic power for wall saw systems
Hydraulic power packs for wall saw systems. The power pack sets the flow and pressure the saw works at, so it must be matched to the saw rather than chosen on size alone.
A hydraulic saw needs the flow and pressure it was designed for. An oversized pack does not make the saw cut faster if the saw cannot use the flow.
In buildings the available electrical supply often sets the practical size of the pack. We size against what the site can actually deliver.
Where we supply the saw too, power pack and saw are specified as one set.
Values we can state from real applications, with the basis for each one.
Every specification above is confirmed against your material, machine and site conditions before an order is placed.
We specify against the job rather than the catalog. These are the facts that decide the answer for anything in Construction Cutting Equipment.
This product is specified as part of a set. These are the wire families and product groups it is normally combined with — final selection depends on the material, the machine and the site conditions.
Actual applications with the equipment, tooling and working conditions recorded.
Clean, precise structural cuts through reinforced concrete spans, with the structure released for the next phase of works.
Cold, precise and safe dismantling of a 4-meter-diameter steel furnace, meeting the plant's safety and shutdown requirements without any thermal cutti
The reinforced concrete block was cut cleanly, and the run was documented on video as the reference demonstration for concrete wire selection.
How this equipment and tooling performs in real quarry and construction conditions.
Send the material, the machine and the working conditions. We will come back with a specification that suits the job — and say plainly where a limit exists.
