Blades built for reinforced wall sections
Diamond blades for wall sawing applications — sized for the saw and specified for reinforced concrete, where the blade must cut concrete and steel reinforcement in the same pass.
Blade diameter is set by the saw and the depth of cut required; the segment specification is set by the material. Both have to be right.
Blades for reinforced sections are built for the interrupted cutting that steel reinforcement causes, where a blade specified for plain concrete will wear unevenly.
Wall sawing runs wet, and adequate water at the cut is what protects both blade and the finished edge quality.
Values we can state from real applications, with the basis for each one.
Every specification above is confirmed against your material, machine and site conditions before an order is placed.
We specify against the job rather than the catalog. These are the facts that decide the answer for anything in Construction Cutting Equipment.
This product is specified as part of a set. These are the wire families and product groups it is normally combined with — final selection depends on the material, the machine and the site conditions.
Actual applications with the equipment, tooling and working conditions recorded.
Clean, precise structural cuts through reinforced concrete spans, with the structure released for the next phase of works.
Cold, precise and safe dismantling of a 4-meter-diameter steel furnace, meeting the plant's safety and shutdown requirements without any thermal cutti
The reinforced concrete block was cut cleanly, and the run was documented on video as the reference demonstration for concrete wire selection.
How this equipment and tooling performs in real quarry and construction conditions.
Send the material, the machine and the working conditions. We will come back with a specification that suits the job — and say plainly where a limit exists.
