Complete wire sawing setup for construction
A complete wire sawing system for construction cutting — machine, pulleys, wire and cooling specified as one working set. Wire sawing is chosen where the section is too thick or too awkward for a blade.
The machine alone does not cut. Pulley arrangement, wire path, tension and cooling all decide whether the cut runs straight and whether the wire survives.
Define the cutting plane, then position the machine, then arrange the pulleys, then install the wire and check alignment and tension. Doing this out of order is how wire is broken.
For thick sections, deep cuts and areas a blade cannot reach, wire sawing is the method rather than a fallback.
Values we can state from real applications, with the basis for each one.
Every specification above is confirmed against your material, machine and site conditions before an order is placed.
We specify against the job rather than the catalog. These are the facts that decide the answer for anything in Construction Cutting Equipment.
This product is specified as part of a set. These are the wire families and product groups it is normally combined with — final selection depends on the material, the machine and the site conditions.
Actual applications with the equipment, tooling and working conditions recorded.
Clean, precise structural cuts through reinforced concrete spans, with the structure released for the next phase of works.
Cold, precise and safe dismantling of a 4-meter-diameter steel furnace, meeting the plant's safety and shutdown requirements without any thermal cutti
The reinforced concrete block was cut cleanly, and the run was documented on video as the reference demonstration for concrete wire selection.
How this equipment and tooling performs in real quarry and construction conditions.
Send the material, the machine and the working conditions. We will come back with a specification that suits the job — and say plainly where a limit exists.
